FORGOT YOUR DETAILS?

User experiences with the bevel heads and machines from Beveltools

Take a look at how the Beveltools products are used and read user experiences

Beveling aluminum with the Bevel Mite® ABIS-06 Premium

Bevel angle 45 degrees

Bevel depth 4 mm

Replacing the bevel head
Roweko
"For me, saving time is a great benefit. With Beveltools, I can make a bevel or radius, with no further finishing. With grinding discs you take much longer and the end result is never as smooth as with Beveltools."

» Read the complete story here
ConFab
“Before we purchased the Bevel Mite® ABIS-06 we were using a bur bit and it would take on average 45 seconds to 1 minute to bevel a 4 cm diameter hole. Now with this tool we are averaging 7 to 10 seconds per hole and that saves a lot of time."

» Read the complete story here

Beveling ST37 steel with the Bevel Mate® EBA-12

Bevel angle 45 degrees

Bevel depth 4 mm

Dutch metal working company
“For a large project, we had to round off a great number of metres and in accordance with NEN-EN 1090. The steel bevel heads by Beveltools lasted 2 to 2.5 times longer in our case than a set of inserts. When Beveltools showed us the Premium bevel head, we immediately started to use it. With just one Premium bevel head we could round off over 200 metres. That is four times more than with a set of inserts!"

» Read the complete story here

Beveling steel pipe S355 with the Bevel Mate® EBA-12 (in 3 runs)

Bevel angle 60 degrees

Bevel depth 10 mm

NG Shipyards
“During the demonstration of the Beveltools products we became enthusiastic, seeing the impeccable end result. We have been working with the Bevel Mite® ABIS-06 for a while now and we are very pleased with it."

» Read the complete story here

Rounding ST52 steel with the Bevel Mite® EBI-06 Premium

3 mm rounding

Jos van den Bersselaar Constructie
“The machine with inserts would already be blunt after using it 2 to 3 times, so that did not work for us. We work a lot with hard materials and laser-cut steel. The Bevel Mate® EBA-12 is truly ideal for rounding the holes in workpieces because of the long tool life achieved and its high level of user-friendliness."

» Read the complete story here

The Bevel Mate® concept works 50% faster and considerably more quietly than a grinding disc and without producing grinding dust. The final result is precise in terms of radius and with no burrs, meaning that finishing is no longer necessary.

Beveling ST52 Plasma cut steel with the Bevel Mate® ABA-12

Bevel angle 37.5 degrees

Bevel depth 4 mm

Ervaring Beveltools Scheepsbouw
Linssen Yachts
“I went on the lookout for a system that would create a rounding in the steel without needing deburring and polishing afterwards. I quickly came across Beveltools. achine is lightweight and handy. I can use it anywhere. The Beveltools R3 and R4 bevel heads we use have a long service life but are easy to replace when necessary."

» Read the complete story here

YouTube

Facebook

TOP